Here are the Safety instructions of the ceramic metering pump for dosing disinfectant and sanitizer in the filling machine.
- The ceramic pump can use hot water, soapy water, alcohol, or other cleaning liquid to clean the internal remnants several times through the reciprocating work of the machine until no residue of the material comes out, then rinse with clean water. Or disassemble it for disinfection.
- When cleaning the internal parts, do not touch the surface of the parts with sharp tools. After cleaning, wait until the parts are dry before installing.
- Check if the sealing ring of each part is damaged, if any, replace the new sealing ring;
- Check if the screws in each part are loose, if any, re-lock.
- Do not flush the motor with cleaning fluid to prevent damage to the components.
- Try to avoid being in a state of no material for a long time when using it.
- It is strictly forbidden to enter hard parts or particles other than materials into the pump head assembly.
- For perfusion of volatile liquids, please use them in a circulating air environment.
- When the machine is working, it is strictly forbidden that any part of the body or other items are close to the moving parts of the machine. The factory is not responsible for the mechanical damage and personal injury caused by the machine.
- The equipment must be disconnected from the power supply when replacing components.
- It is strictly forbidden to use organic flux to clean the machine, such as gasoline, benzene, xylene, banana water, sodium hypochlorite, etc.
- When the machine is shut down, turn off the power switch, unplug the power cord, and clean up the miscellaneous items.
